Master Data Management

Configure Data Download During the Final Finish Process to use a Syniti Data Replication Package

A process Designer can use Syniti Data Replication for change data capture to replace final finish package logic. Change data capture is the preferred method of keeping MDM in sync with target system(s).

If the Finish Type is Syniti Data Replication, then a corresponding Table definition must exist in Collect. Refer to Tables in Collect for more information.

This configuration is for documentation purposes only. MDM does not start or run the downloads. When configured correctly in Collect, the Syniti Data Replication synchronization happens automatically.

NOTE: MDM does not confirm that the table exists when registering a table on the Task Final Finish Tables page. An error displays during the Final Finish if the table does not exist.

NOTE: Refer to Final Finish Process for a Request Overview and Final Finish Setup Example for general information.

To register a Syniti Data Replication package to download a table for the Final Finish process:

  1. Click Master Data Management >Design in the Navigation pane.
  2. Click the Tasks icon for a category.

  3. Click the Final Finish Tables icon for a parent task (i.e., Request (Address – General), as opposed to Request (Address – Telephone/Mobile)).

    NOTE: Best practice is not to register tables to a child task.

  4. Click Add.

     View the field descriptions for the Task Final Finish Tables page

  5. Select DBMoto from the FINISH TYPE list box.
  6. Enter a number in the PRIORITY field.
  7. Click Save; Vertical View displays.
  8. Select a Collect source from the Source list box.
  9. Select a Collect target from the Target list box.
  10. Select the name of the table to download from the Table Name list box.
  11. Click Save.